Switching the headphones on
Warning Danger due to high volume levels! Listening at high volume levels can lead to permanent hearing defects. Before putting the headphones on, adjust the volume to a low level (> Adjusting the volume). ▷Do not continuously expose yourself to high volume levels. |
Automatic switch-on
When the headphones are in the supplied carry case: Take out the headphones from the carry case.
One LED flashes white 3x. The headphones automatically switch on.
Put on the headphones.
You hear a sound signal. If Bluetooth is activated on the headphones and a paired device is available, you hear the voice prompt “Connected”.
If Bluetooth is deactivated on the headphones (> Using the audio cable/activating flight mode), you only hear a sound signal. The active noise cancellation ANC may be activated (> Increasing/decreasing the active noise cancellation ANC and the Transparency Mode).
Manual switch-on
Press the multi-function button for 3 seconds.
One LED flashes white 3x. You hear a sound signal. If Bluetooth is activated on the headphones and a paired device is available, the LED lights up white and you hear the voice prompt “Connected”.
If Bluetooth is deactivated on the headphones (> Using the audio cable/activating flight mode), you only hear a sound signal.The active noise cancellation may be activated (> Increasing/decreasing the active noise cancellation ANC and the Transparency Mode).
 | Make sure that Bluetooth is already activated on your Bluetooth device when switching on the headphones. |
| If Bluetooth is activated and the headphones cannot find a paired Bluetooth device within a few minutes, you hear the voice prompt “No connection”. The LED flashes red 3x. The headphones switch to standby mode. |